Reduce Variables And Liabilities

Increase asset life and the time between shutdowns. Alleviate community concerns and optimize strategic asset management. Sponge-Jet technology replaces disruptive surface preparation practices, reducing up to 30% of shut-down time – while increasing coating life. Ultimately one can extend both operational status and maintain asset value. Non-invasive Sponge Blasting technology allows:

  • Most preparation and coating work to be achieved during regular operations (leaving shutdowns free for other trades)
  • Management to improve, predict and control their operational schedules
  • Management to eliminate community environmental concerns by reducing hazardous fugitive emissions

Testimonials

"In regards to the new technology, our experience has being satisfactory from the technical stand point regarding the operators safety and the impact to the environment. The equipment is reliable and the substrate finish quality is excellent." - Ronmel García, Maintenance & Programing Superintendent, Petrosucre-PDVSA


Risorse addizionali

  • Being Green Good Article

    PDF article describes Sponge-Jet’s greener approach to preserving structural assets and boosting p…

    Scarica
  • Sponge-Jet Introductory Brochure – ITA

    Tecnologia di sabbiatura abrasiva
    a bassa emissione di polvere
    Proteggere ciò
    che è importante
    n L…

    Scarica
  • Hazards of Conventional Abrasives

    PDF magazine article describes health hazards associated with conventional abrasives, including sand…

    Scarica
  • SJ Saves Water in Refinery

    PDF article shows how switching from chemical cleaners to Sponge-Jet at Brazilian refinery helped de…

    Scarica

Recent Blog Posts

  • Surface Prep, Sponge Media and the Miss Ellis Island

    The Miss Ellis Island is one of the boats that carries passengers from the New Jersey-based marina across New York Harbor and onto Ellis Island. Getting ready for the busy summer tourist season includes conducting maintenance on the ferries, and this past year, the Miss Ellis Island was due for some much needed recoating on the walkways and decks.

    Per saperne di più >
  • How to Remove Soot from Concrete?

    When structural fires occur, they leave behind many hours of cleanup even if the fire doesn’t cause much structural damage. After fires, areas with affected masonry surfaces like concrete must be checked by a structural engineer to ensure entry is safe. Once the area is cleared, the restoration process can begin.

    Per saperne di più >
Altri post