Find the pages, products, documents, and resources with a full site search.
Advanced Document Search
Sponge-Jet CVR P110 Continuous VAC-Recovery Systemは、取扱い及び人件費を削減します。この連続再利用・再充填装置により、労力、時間、及びお金の節約が可能です。作業現場でSponge Media™研掃材を再生し、Sponge-Jet Recycler™に自動的に移送します。一次サイクロンホッパーは真空状態のまま粉塵、廃棄物、及びSponge Mediaを回収します。二次ホッパーは、真空を周囲圧力に切替え、真空に支障なく回収した材料をSponge-Jet Recylerに移送します。
CVR-P110独自の特徴は以下の通りです。
空気動式バキューム
2段連続空圧式タイマー回収・放出サイロシステム
バキュームホース 15m (50ft)、内径75mm (3in)
フォークリフトポケット付き調整式スタンド
*重量は出荷パレット、ホース類、付属品を含みません。
**予測移送容量は1/3の垂直距離で作業用配合を100m (330ft)の距離で使用した場合を想定しています。
PDF document comparing abrasive blasting technologies.
ダウンロード
Sponge-Jet_Introductory_Brochure_jpnSponge-Jet
ブラスティング システム
大…
ダウンロード
Commercial coatings specialists involved in deleading and are yearning for larger contracts might find themselves looking to become more highly certified. Increasingly, large public and private entities (including oil companies, departments of transportation, and public utilities) insist contract bidders possess additional certifications from organizations such as SSPC (The Society for Protective Coatings). SSPC certifies both companies and individuals, verifying contractor organizations with defined knowledge and procedures.
もっと読む >
Typically applied thick, polyurea and rubber coatings are notoriously hard to remove. Regular abrasive blasting methods are rarely effective in removing these coatings. Abrasives like garnet and coal slag bounce off these surfaces causing them to heat and become gum-like with little removal. This burned residue should not be coated over and would normally require further surface preparation. To avoid these issues, specifiers, contractors and facility owners have three options for polyurea and rubber coating removal.
もっと読む >